GymMaster Gym Software Manual

Doors and Readers

GymMaster software combined with door access hardware form an access control system which allows automated individualized entry

Tailgating cameras

The tailgating cameras are IP cameras that you install inside the facility, near an access-controlled door. They help GymMaster find persons who follow a member through the door after the member checks in.

How it works

What it does

The tailgating system works with GymMaster access control. It helps to keep the club secure, and it helps to stop unwanted visitors when no staff are at the club.

A member checks in at the door. The cameras look at the corresponding entrance. If a person follows the member in without a new check ins, the entry is flagged as a tailgating.

The cameras and the Gatekeeper must connect to the same router or network device. In GymMaster, the door must have the Detect Tailgating option. After installation, click Request Calibration to start the calibration.

There are two current versions of the system:

  • V4 (one camera): One GymMaster Tailgating IP Camera. Install it inside the facility, directly in front of the door, 2–2.5 meters (6–8 feet) above the floor. The faces of persons who come in must be clear. Try to keep other movement out of the view.
  • V3 (two cameras): Two Honeywell IP cameras.
    • The Overhead camera looks down on the entrance path from as high as possible. Install it at least one meter from the door, or more if the door opens inwards. Each member must go through the centre of its view.
    • The Evidence camera faces the door, usually on the opposite wall. It must show the faces clearly.

Parts and connections

Item Details
Network One Ethernet cable from each camera to the local network (router or switch). Each camera needs one free port.
Gatekeeper One Gatekeeper on the same router or network device as the cameras.
Power A 12V 1A DC power supply for each camera (5.5 mm x 2.1 mm barrel connector, centre positive), or a PoE network switch. The installer supplies the power. GymMaster does not supply power supplies.
PoE budget 12W-15W for each port.
GymMaster settings Go to Settings > Doors & Readers and edit the door. Tick Detect Tailgating. Use Check Cameras to examine the connection, and the Preview buttons to see the camera view. Then click Request Calibration.

Note: The cameras must be connected to the same router as the gatekeeper.

These cameras do not have a data sheet. This page uses the installation guides below.

Next - Key Fobs