GymMaster Gym Software Manual
Doors and Readers
GymMaster software combined with door access hardware form an access control system which allows automated individualized entry
- Hardware
- Gatekeepers: Gatekeeper H6 · Gatekeeper H5 · Gatekeeper H4 · Gatekeeper Mini 4 · Gatekeeper Mini 3
- Door readers: Sentinel Wall Reader · Sentinel Keypad · Cidron · CN485 · CV485
- Desktop readers: Desktop Reader · Sentinel Desktop
- Other: Tailgating cameras · Key Fobs
- Installation and Documents
- Integrate Hardware with GymMaster
- Manage Doors
- Door Access
- Troubleshooting
- Frequently Asked Questions
Desktop Reader
The Desktop Reader (part number HL-RC500) is a flat RFID reader for the reception desk. It connects to a USB port on the Gatekeeper or the Gatekeeper Mini.
How it works
What it does
The Desktop Reader identifies members at reception. Staff can also use it to issue RFID fobs and cards. It cannot open doors.
A member holds an RFID fob or card near the reader. The reader sends the fob data to the Gatekeeper through the USB cable.
The reader gets its power from the USB port of the Gatekeeper. It does not have a power supply of its own.
Parts and connections
| Item | Details |
|---|---|
| Port | One female USB 2.0 Type-A port on the reader. |
| Cable | A standard USB Type-A data cable connects the reader to a USB port at the front of the Gatekeeper. |
| Cable length | Maximum 3 metres (10 feet) between the reader and the gatekeeper. |
| Hubs | Do not use a USB hub or a USB extension. The Gatekeeper does not support USB hubs. Connect the reader directly to the Gatekeeper. |
| LED | One LED in the top right corner. |
| Label | The label on the bottom shows the part number, HL-RC500. |
Lights and sounds
| Indicator | Meaning |
|---|---|
| LED is red after you connect the reader | The reader has power. The Gatekeeper has not detected it yet. |
| LED changes from red to green, with a beep (in 10 seconds or less) | The Gatekeeper detected the reader. The reader is ready. |
| LED stays red | The Gatekeeper did not detect the reader. Connect it to a different USB port and wait 10 seconds. |
| LED changes colour for a short time and the reader beeps | The reader read an RFID fob or card. |
| LED is off | The reader has no power. Examine the USB cable and the Gatekeeper power. |
Specifications
| Item | Value |
|---|---|
| Power consumption | 12W (max) through USB |
| Communication interface | RS232 (USB) |
| Frequency | 13.56MHz (at 1-3 cm or 0.5-1 in) |
| Standard | 13.56MHz: ISO14443A |
| Indicators | LED, sound |
| Operating temperature | -15°C - 65°C |
| IP rating | IP65 |
| Configuration methods | Factory configured |
Related Documents
This reader does not have a data sheet. This page uses the Gatekeeper guides and troubleshooting guides below.
- Gatekeeper H Bench Testing Guide (PDF)
- Reader Troubleshooting Guidelines (PDF)
- Gatekeeper H Technical Instructions (PDF)
- Gatekeeper Instructions H5 v3 (PDF)
- Mini Gatekeeper Instructions (PDF)
- Card Reader Technical Instructions (PDF)
Next - Sentinel Desktop