GymMaster Gym Software Manual
Doors and Readers
GymMaster software combined with door access hardware form an access control system which allows automated individualized entry
- Hardware
- Gatekeepers: Gatekeeper H6 · Gatekeeper H5 · Gatekeeper H4 · Gatekeeper Mini 4 · Gatekeeper Mini 3
- Door readers: Sentinel Wall Reader · Sentinel Keypad · Cidron · CN485 · CV485
- Desktop readers: Desktop Reader · Sentinel Desktop
- Other: Tailgating cameras · Key Fobs
- Installation and Documents
- Integrate Hardware with GymMaster
- Manage Doors
- Door Access
- Troubleshooting
- Frequently Asked Questions
Cidron
The Cidron is a door reader. It is installed on the wall near an access-controlled door, and it connects to a Gatekeeper.
How it works
What it does
The Cidron reader is black. There are four models: two narrow models and two wide models. Each size has one model with a keypad. The part number is on the rear of the reader. It also supports Bluetooth Low Energy (BLE) check-ins.
A member can open the door in three ways:
- Enter their PIN on the keypad, then push #.
- Hold their RFID fob near the reader.
- Connect via the GymMaster App using Bluetooth.
The keypad reads RFID fobs at 13.56MHz (MIFARE Classic and MIFARE Ultralight) and sends the PIN or the fob data to the Gatekeeper.
Parts and connections
| Item | Details |
|---|---|
| Communication | RS485. The reader connects to the Reader 1 or Reader 2 socket on the Gatekeeper. |
| Power | The reader gets 12V from the same Gatekeeper socket. |
| Cable | 4-core cable, 18-20 AWG (for longer runs), or a Cat5/6 cable, between the reader and the Gatekeeper. 100 m (110 yds) maximum. The reader comes with short wires for tests. |
| Wires | Four wires. See the wire table below. |
Do not connect other devices to the reader power wires.
Wires:
| Wire colour | Connection |
|---|---|
| Black | Ground |
| Red | 12V |
| Blue | A |
| Green | B |
Caution: Do not install the reader on metal that conducts electricity and has no earth. Keep the reader away from electrical noise, for example motors and fluorescent lights. If there are two door readers, keep a minimum of 5 cm (2 in) between them.
Lights and sounds
The reader has an LED backlight. You can see it in the ring around the reader, or behind the keys on the keypad model.
| Indicator | Meaning |
|---|---|
| LED is blue | Default idle colour. |
| LED flashed green | Access is granted. |
| LED flashed red | Access is denied. |
| LED is off | The reader possibly has no power. Examine the wires and the Gatekeeper power. |
| LED is always red | The reader does not have setup credentials. |
Related Documents
- Troubleshooting guidelines (PDF)
- Gatekeeper h4.1 instructions (PDF)
- Gatekeeper h5 instructions (PDF)
- Gatekeeper H technical instructions (PDF)
- Gatekeeper H5 v3 installation guide (PDF)
Next - CN485