GymMaster Gym Software Manual

Doors and Readers

GymMaster software combined with door access hardware form an access control system which allows automated individualized entry

CV485

The CV485 is a GymMaster door reader for the Gatekeeper H4. It is installed on the wall near an access-controlled door, and it connects to a Gatekeeper.

How it works

What it does

The CV485 reader is dark grey, with an LED in the center. There are two sizes: wide and narrow. Some of these readers have a hexagonal G logo in the bottom right corner.

A member holds an RFID fob near the reader. The reader sends the fob data to the Gatekeeper.

Parts and connections

Item Details
Communication RS485. The reader connects to the Reader 1 or Reader 2 socket on the Gatekeeper.
Power The reader gets 12V DC from the same Gatekeeper socket.
Cable 4-core cable, 18-20 AWG (for longer runs), or a Cat5/6 cable, between the reader and the Gatekeeper. 100 m (110 yds) maximum. The reader comes with short wires for tests.
Wires Four wires. See the wire table below.

Wires:

Wire colour Connection
Black Ground
Red 12V
White A
Green B

Caution: Do not install the reader on metal that conducts electricity and has no earth. Keep the reader away from electrical noise, for example motors and fluorescent lights. If there are two door readers, keep a minimum of 5 cm (2 in) between them.

Lights and sounds

Indicator Meaning
LED is red for a short time when you connect it The reader gets power from the Gatekeeper.
LED is green Normal state. The card reading software is active.
LED changes from green to red The reader read a valid RFID fob.
LED is off The reader possibly has no power. Examine the wires and the Gatekeeper power.
LED is pulsating red or green The reader has voltage issues and is most likely at the end of its lifetime.
Reader beeps once A fob is being read.
Reader beeps twice Access is denied.

Next - Desktop Reader